File systems and UUIDs on Linux

The /etc/fstab file is a very important file on Linux systems. It contains information that allows the system to connect to disk partitions and determine where they should be mounted in the file system. While this file has played an important role over the years, its format has changed with the introduction of UUIDs and, on some systems, a more reliable file-system type.

Here’s an example of an /etc/fstab file on a Fedora system:

$ cat /etc/fstab
#
# /etc/fstab
# Created by anaconda on Fri Mar 12 12:26:55 2021
#
# Accessible filesystems, by reference, are maintained under '/dev/disk/'.
# See man pages fstab(5), findfs(8), mount(8) and/or blkid(8) for more info.
#
# After editing this file, run 'systemctl daemon-reload' to update systemd
# units generated from this file.
#
UUID=a9e33237-9114-44ae-afd5-8ddb231d301f /             btrfs   subvol=root     0 0
UUID=15f42905-5897-4804-9c51-e6d5e169e6c2 /boot         ext4    defaults        1 2
#UUID=a9e33237-9114-44ae-afd5-8ddb231d301f /home        btrfs   subvol=home     0 0
UUID=d867ced1-8d81-47c6-b299-3365ba8a02de /home         ext4    defaults

Each line in the file (other than the comments) represents a file system and has six fields.

1. describes the disk partition (more on the UUIDs below)
2. identifies the mount point
3. shows the file system type (could be ext4, xfs, btrfs, f2fs, vfat, ntfs, hfsplus, tmpfs, sysfs, proc, iso9660, udf, squashfs, nfs, cifs or something else)
4. provides mount options
5. determines if the file system might be dumped (0 = not) using the dump command (not often used)
6. determines if file-system checking should be done at boot time (0 = not)

The btrfs file system is a modern copy-on-write (CoW) filesystem for Linux that provides advanced features while also focusing on fault tolerance, repair and easy administration.

The /etc/fstab file shown above is unusual in that a new OS was just recently installed on /dev/sda and the /home folder from the system before the upgrade (on a separate disk) was then remounted after the first reference to /home was commented out.

What are UUIDs?

Those lengthy device identifiers that you see in /etc/fstab that are labeled UUID (universally unique identifier) are 128 bit (32 hex characters) long and arranged in an 8-4-4-4-12 character sequence. One way to view how the UUIDs connect with the device names (e.g., /dev/sda1) is to use the blkid command.